To install the child in the bouncer, unlock the 4 fastening points on the restraint system. Pass the two straps on the harness through the two openings on the newborn pillow. To set the incline of the bouncer seat, place your hand on the top of the seat back and press the button at the rear. To use your bouncer in the low position, follow the assembly instructions above without inserting the large tubes (A). INSTRUCTIONS FOR SETTING THE INCLINE AND FOLDING To do this, fold the seat structure, place over the back and then over the seat. Position the handles (E) by pressing down on the spring buttons and inserting them in the large tubes (A). Always ensure that the seat structure is facing the right way (seat on the same side as the stabiliser). Remove the handles (E) by pressing on the spring button and unfold the seat structure (G) following the instructions for setting the incline. Press on the locking buttons on each side of the seat structure and release at the desired position. The three holes on the large tube must be facing towards the inside of the bouncer. Position the large tubes (A) by pressing on the spring buttons and inserting them in the small tubes (B). Fasten the knuckles (C) and the small tubes (B) to the frame with the screws (D).

Always ensure that the knuckle is placed in the same direction as the tube and that the nut hole on the knuckle is facing towards the inside of the bouncer.

In order to avoid assembling the product incorrectly, always ensure that the polarising slots are aligned correctly. Â¢ Protect the product from atmospheric agents (rain, snow, etc. Â¢ Always dry the productâs metal parts in order to prevent the formation of rust. â¢ This bouncer does not replace a Moses basket or a cot. Â¢ This bouncer is not intended for long periods of sleep. KEEP THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE

Bertini cot instruction manual